ParaBody 400102 manual Silicon or teflon spray available at most hard Ware stores

STEP 15
• Securely assemble the WEIGHT STACK SHAFT
(80) to the HEAD PLATE (81) using one 3/8 X 1-1/			89
4” BOLT (46) and one 3/8” WASHER (51).
• Insert two GUIDE RODS (33) into the WEIGHT			33
STACK BASE (3) as shown on FIGURE 15.
(NOTE: Lubricate GUIDE RODS (33) with
silicon or teflon spray available at most hard-			81
ware stores.)
• Slide two WEIGHT STACK SPACERS (34), two			51
3/4” WASHERS (53), and two WEIGHT STACK		3/8 X 1-1/4” 46
CUSHIONS (88) - IN THAT ORDER - down
over the GUIDE RODS (33).
			80
• Using EXTREME CARE slide	all fifteen
WEIGHT PLATES (74) down over the GUIDE		74
RODS (33) on to the WEIGHT STACK CUSH-
IONS (88). Make sure that the keyholes of the
WEIGHT PLATES (74) are all facing the right
way.
• Slide the head plate assembly down over the		57
GUIDE RODS (33) onto the weight stack.
• Insert two CAP PLUGS (89) into the top ends of the			88
			53
GUIDERODS(33).
		34
• Attach the WEIGHT STACK LABELS (94) to the
weight stack. Also insert the WEIGHT STACK
PIN (57) into the first WEIGHT PLATE (74) of
the weight stack.				3
		FIGURE 15
44 1/2 X 4”				STEP 16
52	7			• Swing the GUIDE RODS (33) under the TOP
				BOOM (7) as shown on FIGURE 16.
		48
16		51		• Loosely assemble the TOP BOOM (7) to the
				REAR UPRIGHT (16) using two 1/2 X 4”
				BOLTS (44), two 1/2” WASHERS (52), and
	Route LAT			one 1/2” LOCKNUT (49).
	CABLE over bolts			• Loosely assemble the TOP BOOM (7) to the
		51
33				FRONT UPRIGHT (11) using two 3/8 X 3”
			92	BOLTS (39), four 3/8” WASHERS (51), and
		39 3/8 X 3”		two 3/8” LOCKNUTS (48). Make sure LAT
		11		CABLE (92) is routed OVER top of bolts.
49
		FIGURE 16
		12