Paradyne DSL Configuration Ports Screens

3. DSL Card Configuration
3-8 April 2001 8000-A2-GB26-50
DSL Configuration Ports Screens
Use the system information submenu of the Ports screens to display the DSL
Ports screen. This screen contains options for the physical layer of the selected
interface. The following screen example is for DSL port cards with an Ethernet
Network interface. The port cards with an ATM Network interface only allow you to
select DSL Ports.
Procedure
To configure ports:
1. Follow this menu selection sequence:
Configuration
→
Ports
(A-B)
2. The Ports menu appears. Enter the desired value on each selected screen
and field as shown in Table3-2, Ports Optio ns, and press Enter. Use Ctrl-v to
display a pop-up list of selections within certain fields.
Table 3-2. Ports Options (1 of 9)
Ethernet Port (8510/8373 RADSL, 8310/8312 MVL and A-B-A
8312 ReachDSL/MVL Cards)
This selection is available for 8510/8373 RADSL, 8310/8312 MVL and
8312ReachDSL/MVL cards. It provides the ability to configure duplex mode on the
Ethernet port.
Port Name – Enter the number of the Ethernet port.
Full Duplex – Enter enable for full-duplex mode or disable for half duplex mode
(Default = Disable).
Interface State – Displays whether the port is enabled, not selected, etc.
Action – Edit/Reset. Select Edit to configure the port. Select Reset to have changes
become active.