Paradyne Configuring Static Users

3. DSL Card Configuration
8000-A2-GB26-50 April 2001 3-23
Configuring Static Users
You must perform this procedure if you have static users unless you are using a
DSL Router and operating in Standard mode set on SCM card. You can configure
up to 32 host entries or subnet entries per DSL interface. For more information
about the fields listed in this procedure, see Table 3-4, Bridge Options
.
NOTE:
Do not assign the same subnet to multiple ports.
Procedure
From the Hotwire – DSL menu:
1. Follow this menu s election sequence:
Configuration
→
Bridge
→
Client VNID Table
(A-E-E)
2. En ter the name of the interface at the DSL Interface Name: prompt. Enter
1 through 4 for 4-port DSL cards, 1 through 12 for 12-port DSL cards, or 1
through 24 for 24-port DSL cards.
3. Type 0 or press Enter at the User: prompt.
4. En ter the IP Address of this user at the Enter client IP address
(nnn.nnn.nnn.nnn): prompt. Enter the IP addresses of all clients behind
the nonrouter SN if IP Scoping or IP Filtering is enabled.
If using a DSL Router, enter its IP address. Also enter the IP address of all
clients behind the DSL Router if IP Filtering is enabled.
5. En ter the subnet mask at the Enter Subnet Mask (nnn.nnn.nnn.nnn):
prompt.
6. Wh en using a subnet with a nonrouter SN, enter the IP address of the next
hop router for this client at the Enter IP address of next hop router
(nnn.nnn.nnn.nnn): prompt. The address used must be part of the
subnet that is attached to the nonrouter SN. When using a DSL Router, enter
the IP address of the NHR.
7. En ter the VNID for this user at the Input VNID ID: prompt. If VNID tagging
is disabled, None appears in this field.
8. En ter yes at the yes/no: prompt to save your changes.
NOTE:
Static IP address configuration is not required when the DSL por t is
configured in Standard mode.