Paradyne Hotwire 5446 installation instructions Status LEDs, Condition Status

Status LEDs

All of the LEDs turn on and off during the power-on self-test. After a successful self-test, the LEDs should appear as indicated in BOLD in the Condition column below.

LED	Condition	Status
PWR	ON	RTU has power.
ALM	OFF	No active alarms.
	ON	An alarm condition exists.
TST	OFF	No active tests.
	ON	The TST LED is on during the power-on self-test and
		during a test initiated by the NSP.
DSL	Fast	RTU is establishing the active DSL link. The LED blinks
	blinking	on and off about five times per second.
	Slow	The DSL link is up and the RTU is establishing the active
	blinking	PPP link. The LED blinks on and off every two seconds.
	ON	The DSL/PPP link is ready to transmit and receive data.
	OFF	The DSL link has not been established.
ETHERNET	ON	The Ethernet 10BaseT connection to the Ethernet hub or
		PC is active.
	OFF	No Ethernet 10BaseT device is detected.

13