Paradyne installation instructions Installing the Hotwire 5446 RTU, Hotwire RTU, Pots Splitter

Installing the Hotwire 5446 RTU

Place the Hotwire 5446 RTU on a flat surface with clearance for the rear connectors.

"Procedure

1.Use the supplied RJ11 6-pin interface cable for the DSL connection. Insert one end of the cable into the jack labeled DSL. Insert the other end into the wall jack labeled DSL.

Hotwire RTU

POWER

DSL

Jack

ETHERNET

DSL

97-15300-01

If the Hotwire 5446 RTU is installed on the same line as POTS, a Hotwire 5038 Distributed POTS Splitter can be used as a filter. One 5038 Distributed POTS splitter is installed as a filter for each telephone, as shown below. To install the Hotwire 5038 Distributed POTS splitter, refer to Hotwire 5038 Distributed POTS Splitter Customer Premises Installation Instructions.

Customer

Premises (CP)

Distributed

POTS Splitter

LINE DSL PHONE

Line from

RJ11 Wall Jack

LINE DSL PHONE

Distributed

POTS Splitter

Distributed		Hotwire
POTS Splitter		RTU
PHONE	LINE DSL

Line from

RJ11 Wall Jack

98-15813

8