Using the Parrot PARTY for the first time
Note : The batteries are neither fully charged nor fitted when you unpack the Parrot PARTY. You have to insert and charge them before using the Parrot PARTY for the first time.
1.Remove the cover from the battery compartment underneath the device.
2.Insert and connect the batteries into the compartment as shown in the diagram below.
3.Replace the cover.
4.Connect the power lead supplied to the Parrot PARTY, making sure that it is fully inserted, and then plug the lead into the mains supply.
5.Turn on the Parrot PARTY using the ON/OFF switch on the back of the device.
>The centre LED on the Parrot PARTY flashes red/blue and then turns violet: this colour means that the device is charging. The LED turns blue when the batteries are fully recharged.
CAUTION
BLAST RISKS MAY OCCUR IF THE BATTERY IS REPLACED WITH AN
INCORRECT BATTERY TYPE.
THROW USED BATTERIES IN THE GARBAGE IN COMPLIANCE
WITH THE PROVIDED INSTRUCTIONS.
US | EU | UK |
•The battery charging time is approximately four hours.
•The Parrot PARTY can be used while the batteries are being recharged.
•You can use the Parrot PARTY for up to four hours on fully charged batteries.
•When the batteries are almost flat, the LED on the Parrot PARTY turns red. You have about 15 minutes’ listening left.
•Make sure the Parrot PARTY is not exposed to a high temperature while being charged.
Meaning of the leds
COLOURS | MEANING | |
|
|
|
Flashing red/blue | The Parrot PARTY is automatically | |
| setting up. | |
| > Wait a few seconds. | |
|
|
|
Red | Low battery level: listening time less | |
| than 15 min. | |
| > Plug the Parrot PARTY into the | |
| mains. | |
|
|
|
| 13 |
|
|
| |
|
|
|
