Patton electronic 1069 user manual Connecting The Line Interface

3.1 CONNECTING THE LINE INTERFACE

The Interconnecting cables shall be acceptable for

external use and shall be rated for the proper applica-

tion with respect to voltage, current, anticipated tem-

CAUTION perature, flammability, and mechanical serviceability.

The Model 1069 supports communication over a distance of up to 10,000 ft (3 km) over 24 AWG (0.5 mm) twisted-pair wire or Cat5+.

Note Actual distance and link performance may vary depending on the environment and type/gauge of wire used.

Follow the steps below to connect the Model 1069 interfaces.

1.To function properly, the Model 1069 must be connected with the VDSL2 DSLAM using twisted-pair, unconditioned, dry, metal wire, between 19 (0.9mm) and 26 AWG (0.4mm). Leased circuits that run through signal equalization equipment are not acceptable.

2.The Model 1069 is equipped with an RJ-45 interface jack that can be used on the VDSL2 link interface. The VDSL2 link interface is a two- wire interface. Observe the signal/pin relationships on the Model 1069's VDSL2 interface jack.

The RJ-45 connector on the Model 1069's twisted pair interface is polar- ity insensitive and is wired for a two-wire interface. The signal/pin rela- tionship is shown in Figure 4.

	1 (no connection)
1	2 (no connection)

23 (no connection)

44 (RING)

55 (TIP)

6	6 (no connection)
7
	7 (no connection)
8

8 (no connection)

Figure 4. Model 1069 (RJ-45) twisted pair line interface.

10