Patton electronic 12168 user manual Rack Card Installation, 1068DVRC 1068DRC

3.2 RACK CARD INSTALLATION

The Model 1068 rack card version comprises a front card and a rear card.Do the following to install the cards into the rack chassis:

1.Slide the rear card into the back of the chassis along the metal rails.

2.Secure the rear card using the supplied metal screws.

3.Slide the front card into the chassis until you feel resistance as the front card engages the rear card. When that happens, gently push the front card forward until it is fully seated in the card-edge recepta- cle of the rear card (it should click into place).

4.Secure the front card using the captive fasteners.

Note The Model 1001R14 chassis supports “hot swapping” of cards, so it is not necessary to power down the rack when you install or remove a Model 1068 rack card.

VLINK

RJ-45 interface

VLINK

terminal block

Ethernet

Port

		VLINK
		RJ-45 interface
		VLINK
	VLINK	terminal block
VLINK	POTS/ISDN	Port
		POTS/ISDN
		Port
		Ethernet
	Ethernet
Ethernet	1068DVRC

1068DRC

Figure 3. Model 1068 rack cards

5.Connect the line interface between the units (refer to section 3.3, “Connecting the Twisted-Pair Line Interface” on page 11)

Note See Figure 3 for the rack card’s panel arrangements.

10