Note Pin-out requirements for tail circuit applications vary between equipment manufacturers. If you have any questions about a specific installation, please contact Patton Electronics Technical Support.
4.5 CONNECTING TO A G.703/64 KBPS NETWORK
The Network Line Interface is an 8-position keyed modular jack config- ured as an RJ-48C (see Figure 11).
| 1 | RX data (TIP) | From network |
| 2 | RX data (RING) |
1 | |
3 (no connection) | |
2 | |
3 | 4 TX data (TIP) | To network |
4 | 5 TX data (RING) |
5 | |
6 | 6 (no connection) | |
7 | |
8 | 7 (no connection) | |
8 (no connection)
Figure 11. NetLink-E1 twisted-pair interface
Note If the 2073RC is being used for private short-range modem applications, the twisted-pair cable connected to its port will need to be a cross-over cable.
