Patton electronic 2160 Series, 07M2160-GS manual Model 2160 rear panel, Port descriptions

Model 2160 Series Getting Started Guide 1 • General information

Model 2160 rear panel

Port descriptions

The CopperLink™ Model 2160 rear panel ports are shown in figure 3 and described in table 3.

DC 9V

CONSOLE

RST

LAN

1

2

3	MGMT
4

LINE

DC 9V				LAN
		CONSOLE			MGMT	LINE
		RST
+	-	1	2	3	4

Power		Reset button
	Console		LAN (1-4)
	RS-232 port		RJ-45 port

Management		Ground
RJ-45 port
	Line
	RJ-45 port

	Figure 3. Model 2160 rear panel
		Table 3. Port descriptions
Port		Description
DC 9V		Power adaptor inlet: Input voltage 9VDC
Console (RS-232 control port)		Used for service and maintenance, the Console port, an RS-232
		RJ-45 connector with EIA-561 pinout, connects the router to a
		serial terminal such as a PC or ASCII terminal (also called a dumb
		terminal). Asynchronous default data rate 9600 bps, hardware
		DSR and DTR signals for external modems are wired directly
		together internally
RST		Reset button for rebooting or loading factory default settings
LAN (LAN Ethernet Ports 1-4)		10/100Base-Tx full-/half-duplex, RJ-45, auto detection and fall-
		back, connects the unit to an Ethernet LAN.
MGMT		RJ-45 for management port
LINE		Interface for WAN port (RJ-45)

Note For port pinout information, see Appendix C, “Port pin-outs”on page 105.

Model 2160 rear panel 20