Patton electronic 3034/3038 manual Connecting the 10/100Base-T Ethernet LAN and WAN cables

Model 3034/3038 Getting Started Guide 3 • Model 3034/3038 installation

Connecting the 10/100Base-T Ethernet LAN and WAN cables

The Model 3034/3038 has automatic MDX (auto-crossover) detection and configuration on all Ethernet ports. Any of the ports can be connected to a host or hub/switch with a straight-through or cross-over wired cable.

1.Connect to the subscriber port of the broadband access modem (Cable, WLL) to ETH 0/0.

2.Connect port ETH 0/1 to your LAN.

For details on the Ethernet port pinout and cables, refer to Appendix C, “Cabling” on page 49 and Appendix D, “Port pin-outs”on page 52.

Connecting the Composite port

Models with a V.35 port (3034/C and 3038/C).

1.Plug the V.35 WAN cable’s DB-25 end into the units’s Composite connector.

2.Plug the other end of the cable into the V.35 device.

3038/ C Models - V.35

			V.35
	Reset
Power	button		interface
connector		Ethernet ports		RS-232 ports

Figure 6. V.35 interface models

Models with an X.21 port (3034/D and 3038/D).

1.Plug the X.21 WAN cable’s DB-15 male end into the DB-15 connector (labeled Composite) on the 3034/3038.

2.Plug the other end of the cable into the X.21 device.

3038/ D Models - X.21

			X.21
	Reset
Power	button		interface
connector		Ethernet ports		RS-232 ports

Figure 7. X.21 interface models

Models with a T1/E1 port and BNC Connectors (3034/K and 3038/K).

Connecting to the T1/E1 RJ-48C port

Installing the Model 3034/3038 25