Patton electronic 3034/3038 External DC Power Supply, To Power Supply Jack, To -48VDC, Source

Model 3034/3038 Getting Started Guide 3 • Model 3034/3038 installation

External DC Power Supply.

•Do not connect power to the DC Mains at this time.

• There are no user-serviceable parts in the power supply sec

WARNING tion of the Model 3034/3038. Contact Patton Electronics Technical support at (301)975-1007, via our web site at http://www.patton.com, or by e-mail at support@patton.com, for more information.

A 48VDC to 5VDC adapter is supplied with the E48 version of the Model 3034/3038.

1.The barrel power connector plugs into the barrel power supply jack on the unit.

2.The black and red leads connect to the DC source (nominal 48VDC).

The Power LED blinks as the unit is powering up. When the Power LED stops blinking and remains lit, the unit is ready for user configuration. (See figure 3 on page 18).

To Power

Supply Jack

Barrel power connector

MADEINCHINABYSUNNY	S/N:G01234567890	OUTPUTPOWER:5WMAX	OUTPUT:+5V1.0A	INPUT:36-60V0.2AMAX	MODEL:SYD1106-0505	SWITCHINGPOWERSUPPLY		To -48VDC
							-Vin	Source
							+Vin

Black lead (-V)

Red lead (+V)

Figure 9. Connecting DC Power to the 3034/3038 DC Power Supply

This chapter leads you through the basic steps to set up a new Model 3034/3038. Setting up a new Model 3034/3038 consists of the following main steps:

Note If you haven’t already installed the Model 3034/3038, refer to chapter 3, “Model 3034/3038 installation” on page 21.

•Connecting the Model 3034/3038 to your laptop PC

•Configuring the desired IP address

•Connecting the Model 3034/3038 to the network

Installing the Model 3034/3038 28