Patton electronic 3034/3038 Command Line Interface CLI, Example - show cont terminal command

Model 3034/3038 Getting Started Guide 5 • RS-232 port configuration

Command Line Interface (CLI)

The following commands are used to configure the terminal interfaces:

Table 7. Stat Mux- CLI Commands
Step	Explanation
configure controller terminal	Enter the serial controller configuration mode.
<0-7>
clear	Reset the statistics shown in the show command.
data {5,6,7,8}	Set the data bits of the terminal interface.
flow {none,rtscts,xonxoff}	Set the flow control of the terminal interface.
mode {none,master,slave}	Set the mode of the terminal interface. An interface can only
	operate in one mode at a time.
mode master <A.B.C.D>	Enable master mode, configure remote IP address, and config-
[<0-40000>]	ure optional port number. If no port number is specified, the
[allow-remote-control]	default port value is 30000 plus the number of the terminal
	interface (ie 30001 for terminal interface 1). Enable remote
	control of the port.
mode slave [<0-40000>]	Enable slave mode and configure optional port number.
parity {even, mark, none, odd,	Set the parity of the terminal interface.
space}
show	Display the configuration and statistics for this interface.
[no] shutdown	Enables or disables the terminal interface.
speed <50-230400>	Set the baud rate of the terminal interface.
stop-bits {2,1.5, 1}	Set the baud rate of the terminal interface.
show cont terminal	Show configuration of all terminal interfaces

Example – show cont terminal command:

PortSpeedParity		Flow	Data Size		Stop Bits
0	9600 none	none		cs8		one
1	9600 none	none		cs8		one
2	19200 even	none		cs8		one
3	9600 none	none		cs8		one
4	19200 none	none		cs8		one
5	19200 none	none		cs8		one
6	9600 none	none		cs8		one
7	9600 none	none		cs8		one

Command Line Interface (CLI) 36