Patton electronic 3088 Series user manual 3088 K/T Models, Configuring the DIP switches

Model 3088 Series User Manual 2 • Configuration

Table 2. RocketLink-G configurable parameters (Continued)

Parameter	Description	Possible Values
DSL Error Monitor	The length, in seconds, of an interval.	1–255
Interval Time
DSL Error Monitor	The number of errored intervals allowed before restarting the DSL	1–255
Interval Count	link.
DSL Error Monitor	The number of intervals to inspect before disabling the error mon-	0–255
Total Intervals	itor.
DSL Error Monitor	The length, in seconds, to wait after DSL link comes up before	0–255
Startup Delay	enabling the error monitor.

a. For T1 operation, pass framing must be enabled (see Pass Framing parameter for details).

Configuring the DIP switches

The Model 3088 is equipped with two sets of DIP switches, which you can use to configure the RocketLink-G for a broad range of applications. This section describes switch locations and discusses the configuration options available.

Note By default, the RocketLink-G’s DIP switches are all set to “ON” so the NTU can be configured via RocketLink Plug ‘n’ Play from a 3096RC. If that is how you will be configuring the NTU, skip ahead to section “Con- sole” on page 32. Otherwise, read the following sections to manually config- ure the DIP switch settings.

The two sets of DIP switches are externally accessible from the underside of the Model 3088 (see figure 4).

1 2 3 4 5 6 7 8

ON

1		ON
2
3
4
5
6
7
8
	S1

		8
		7
		6
		5
		4		8
		3		7
		2		6
ON		1		5
				4
	S1			2 3
			ON	1

						S2
		tseT 407		3 07.	G	3088 C/D Models
			.G/
s ed	oM

	RocketLink
NTU	G-

						7 .	G
			T 40	7G.	/30
sed	oM	t	se

	RocketLink
NTU	G-

S2

3088 K/T Models

Figure 4. Underside of Model 3088 showing location of DIP switches

Introduction 22