Patton electronic 3088 Series S2-6 through S2-8 Line Type Models 3088/K and 3088/T, Console

Model 3088 Series User Manual2 • Configuration

Table 18. S2-4 and S2-5 Clock Mode Settings

S2-4	S2-5	Clock Mode	Description
OFF	OFF		Reserved

S2-6 through S2-8: Line Type (Models 3088/K and 3088/T)

The RocketLink-G has two different line types, T1 and E1. T1 has three different settings, and E1 has five dif- ferent settings.

Table 19. S2-6 through S2-8 Line Type Settings

S2-6	S2-7	S2-8	Line Type
ON	ON	ON	T1-Unframeda
OFF	ON	ON	T1-SuperFramea
ON	OFF	ON	T1-ExtendedSuperFramea
OFF	OFF	ON	E1-Unframed (G.703 Clear Channel)
ON	ON	OFF	E1-Structured (G.704)
OFF	ON	OFF	E1-CRC
ON	OFF	OFF	E1-Multiframe
OFF	OFF	OFF	E1-CRC Multiframe

a.For T1 operation, pass framing must be enabled (see Pass Framing param- eter in table 2 on page 20 for details).

Console

The 3088 offers a console command line interface. To access the console, use a VT100 emulator configured to 19,200 kbps, 1 stop bit, no parity, and XON-XOFF flow control. Log into the unit using the default pass- word. No username will be needed.

Note For software release 2.1.2, log in with the default password patton.

For software release 2.1.3, log in with the default password superuser.

Through the console, the following variables can be configured:

•Password: The password used to login to the console.

•Circuit ID: The circuit ID communicated to other units via EOC. EOC (Embedded Operations Channel) is an out-of-band channel specified in the G.991.2 standard for SHDSL. We use standard EOC messages for our remote loopback. The 3088 also supports proprietary EOC messages that allow a 3096RC to con- figure it.

•Clock Mode: The following options are available:

-Internal: The internal oscillator in the 3088 provides the clock to both the serial/T1/E1 and DSL interfaces.

-Network: The T1/E1 interface provides the clock for the DSL interface (T1/E1 only).

Introduction 32