Patton electronic 3201 2.0 Configure the IP address, Models with external DC power supply

Terminal

block

			Su			le
					ower
13A.	)
	-	N/C
0
	(SELV)
	60VDC,			+
	–				(
		36	Input:

					+)tr
					C(
	lyppuS					A1,
							t:u
					leudo		5V
	)		re			M	tpu
				wo			O
A31.0,	-	/CN			P C
	)			+	DV
CD	VLE	(S					84
V0				(
	6–63		ut:
			pIn

(-) Terminal

(+) Terminal

Figure 1. 48VDC power supply

1.2 Models with external DC power supply

1.Strip insulation 1/4-inch from the electrical wires that will connect the DC power source to the 48VDC power supply terminal block (see figure 1).

2.Connect the negative (-) terminal from the power source with to the negative (-) terminal on the power supply.

3.Connect the positive (+) terminal from the power source with to the positive (+) terminal on the power supply

4.Connect the 48VDC output barrel-type plug to the Power connector on the DiamondLink.

1.3 Power-up indication

The Power LED blinks as the DiamondLink is powering up. When the Power LED stops blinking and remains lit, the DiamondLink is ready for you to configure.

2.0 Configure the IP address

The DiamondLink is shipped with a factory-configured IP address assigned to the Ethernet LAN port (green out- line). The address is 192.168.200.10/24. In most cases, you must change the address to be on the same subnet as your PC, as described in the procedures below. If you are not sure which IP address to use for your installa- tion, contact your network administrator.

DiamondLink 3201 & 3241 Quick Start Guide 3