5.Adjust the supply holder guides so the sides barely touch the roll. Make sure the supply roll turns freely. If you are using fan-fold supplies, place the supply stack behind the printer, label side facing up.

Supply

Holder

Guides

6.Push down on the supply lever to unlock the supply guides.

7.Lay the label strip across the supply guide so that a few inches extend past the front of the printer. Tuck the supply under the nibs and in between the die cut sensor.

For fan-fold supplies, lay the label strip over the supply holder and across the supply guide so that a few inches extend past the front of the printer. Tuck the supply under the nibs and in between the die cut sensor.

8.Adjust the supply guides so they touch the supply. Push up on the supply lever to lock the supply guides into place.

Die Cut Sensor

Nibs

Supply

Lever

4

Page 4
Image 4
Paxar Monarch 9825 manual Supply Holder Guides