Paxar Monarch 9825 manual J u s t i n g t h e W i d e / N a r r o w K n o b s

3.Feed the backing paper over the peel bar.

4.Feed the backing paper through the lower opening of the exit cover. Close the exit cover. Pull down firmly on the backing paper to remove any slack.

Peel

Bar

Lower	Tear
Opening	Edge

Backing

Paper

When removing the backing paper, pull up across the saw-toothed tear edge. Make sure the backing paper tears at the edge.

5.Close the printer's cover.

6.Press Feed/Cut to position the supply under the printhead.

A d j u s t i n g t h e W i d e / N a r r o w K n o b s

You may need to adjust the two wide/narrow knobs according to the width of your supply. For supply that is more than two inches, adjust the knobs to the wide setting. For supply that is two inches or less, adjust the knobs to the narrow setting. For linerless supply, use the narrow setting (knobs are up).

You must adjust both of the knobs to the same position. If you experience ribbon smudging in cold, dry environments, adjust the wide/narrow knobs to the wide setting.

For wide supplies, push down and turn the wide/narrow knobs clockwise with a screwdriver. For narrow supplies, turn the wide/narrow knobs counter-clockwise with a screwdriver until it pops back up.

The adjustment is shown in the wide position.

6