cool. If the error persists, call Technical Support.

751Printer did not sense a black mark when expected. The supply may be jammed. For errors 751-753, Check the supply tracking, supply marks, black mark sensor position, and supply roll for binding. If the error continues to appear, change the supply.

752Printer sensed a mark in the wrong place.

753Printer sensed a mark that is too long.

755Printhead is open. Close the printhead before continuing. If the error persists, call Technical Support.

756The printer is out of supplies. Load supplies.

757Load supplies. The calibrated supply length differs by plus or minus

.25 inches from the format.

758Check supply. Either the supply is not seen or the on-demand sensor is broken. Check for a label jam. Clear the supply path or reload supplies. This error may occur if you remove a label too quickly in on-demand mode. The printer does not recalibrate after this error.

762Low battery. Recharge the battery.

763Waiting to dispense label. Press the trigger.

765Printhead failure. You need a new printhead. Call Technical Support.

770The print motor is not ready. Call Technical Support.

771The format was not found. Recreate the format, and try again. If the problem continues, call Technical Support.

790The printer is busy. Turn off the printer. Wait two seconds and turn it back on. Resend the packets. If the problem continues, call Technical Support.

791The printer has an error pending. Turn off the printer. Wait two seconds and turn it back on. Resend the packets. If the problem continues, call Technical Support.

Troubleshooting 12-11

Page 171
Image 171
Paxar Monarch Pathfinder Ultra Gold manual