12-10 Troubleshooting
580 Out of memory. Try to reallocate memory. Resend the packet. If the
error persists, call Technical Support.
603 Internal software error caused by the batch not being held. Turn off
the printer. Wait two seconds and turn it back on. If the error
persists, call Technical Support.
611 Font, bar code or density is invalid. The font, bar code or density in
the batch does not fit the format.
612 The data in this line of the batch is either missing or does not match
the format.
613 Reference point off tag.
614 Portion of field off tag. There may be an invalid character in the
packet. Make sure you did not enter O for ∅.
615 Bar code width is greater than 16 inches or the number of keywords
for your PDF 417 bar code exceeds 928. Decrease the density or
shorten the amount of data to print the bar code.
616 Dot shifting failed. A bad dot falls on a bar code that cannot be
shifted. Call Technical Support.
618 Magnification must be 1 to 7.
Machine Faults Errors 700 to 799 occur when there is a problem with the printer.
703 The printer sensed a calibration of different-sized black marks. Make
sure the correct supply is loaded.
704 Printer has not sensed a supply mark within the specified number of
inches or out of supplies. Check the supply tracking, supply marks,
black mark sensor position, and supply roll for binding. If the error
continues to appear, change the supply.
706 The printer’s motor stalled.
730 A memory allocation error occurred during initialization.
750 Printhead is overheated. Turn off the printer to let the printhead
l Ifth it llT h i lS t