Peavey Century Series owner manual Vx Stereo Input Module, Gain & R Gain Controls

VX CENTURY SERIES

	STEREO
		—
			+48V
			LINE
			PAD
		40		GAIN
30
				50
	20		70
	80		150
	40			300
	20		400
			HPF
			Ø
		INSERT
	5		12
	2			18
	1K		20K
	–	O	+	HF
	8			8
	16		16
	1K5		4
600
				5
	300		8K
	–	O	+	MID
	8			8
	16		16
	300		500
100				6
	40		1K
	–	O	+	LF
	8			8
	16		16
			EQ IN
	4	5	6	1
	3			7
	2			8
	1			9
	0		10
	4	5	6	2
	3			7
	2			8
	1			9
	0		10
	4	5	6	3
	3			7
A 2				8
U	1			9
X	0		10
S	4	5	6	4
E	3			7
N
D 2				8
S	1			9
	0		10
P	4	5	6	5
U
S	3			7
H 2				8
O	1			9
N	0		10
-		5		6
O	4		6
F	3			7
F	2			8
	1			9
	0		10

		0
P		4	5	6	5
U	3
S					7
H 2					8
O	1				9
N		0		10
-			5		6
O		4		6
F	3				7
F

28

1 9

0 10

4 5 6 7

3 7

28

1 9

0 10

4 5 6 8

3 7

28

19

0 10

STEREO

IMG	MONO	LR
WID		BAL
		LCR
		BAL
STR		REV
	MUTE
M		L
		C
		R
L		S
R		U
		M
1		2
3		4
5		6
7		8

1	SOLO
PK
L	VCA
SIG
PK
R
SIG	10

V

C

A 0

G

R

O

U

P

S

1		5
-
8
			10
			15
M			20
			30
U
T			40
E
G			60
R
O
U
P
S
A
-
D
	SAFE

Vx Stereo Input Module

The Vx Stereo Input module is essentially two Vx Input mod- ules packaged to fit into a one-module space. This module is very useful for accepting remote feeds, effects outputs and other signals that require stereo handling.

48V Phantom Power Switch

Applies 48 Volts DC to pins 2 & 3 of the both L and R XLR inputs, for microphones requiring phantom power.

LINE Switch

Switches between the balanced XLR Microphone Input con- nector and the balanced Line Input 1/4" TRS connector for both L and R channels.

PAD Switch

Introduces a -20 dB attenuation to the mic input signal for both L and R XLR inputs.

L GAIN & R GAIN Controls

These concentric controls adjust input gain for proper signal level for both Left and Right inputs. Maximum gain is 70 dB. Inner knob is for L GAIN, outer knob is for R GAIN.

Adjustable High Pass Filter w/LED

For both Left and Right inputs, reduces all low frequency con- tent at a -12db per octave rate adjustable from 20 to 400 Hz (- 3dB point). Yellow LED illuminates when switch is down.

Polarity Reverse Switch w/LED

For L&R channels, inverts the polarity of both the microphone and line inputs. An internal jumper selects between Left chan- nel only or both Left & Right channels (default). When this switch is pushed, an associated LED lights.

INSERT Switch w/LED

Activates the insertion point. The send is always on. Audio from the return is switched into the channel when the switch is pressed.

Three-Band Sweep Equalizer Controls

The equalization controls in this module act upon both L and R stereo channels at once. All three EQ bands are set up as sweep EQ’s: the lower knob controls the boost or cut (16 dB); while the upper knob controls the center frequency adjusted by the lower knob. Center frequencies are indicated around the upper knob.

EQ IN Switch w/LED

Inserts the EQ section into both L and R input channel signals at once. An associated green LED illuminates when the switch is down.

AUX SENDS 1- 8 indiv. level controls

The Aux Individual Level Controls send a summed (L+R) sig- nal to the AUX outputs. These Push-On/Push Off pots adjust signal level sent to respective Aux buses. Pushing the switch down turns the send on or off. An associated two color LED indicates status: OFF indicates an 'off' state; GREEN indicates the Aux send is on, and not muted; RED indicates the Aux send is on, but muted. The signal source for these mixes may be selected (by Aux bus) to be pre or post fader by GLOBAL switches located in the Vx Master section.

PAGE 14