Peavey CS 800H manual Specifications

CS® 800H

SPECIFICATIONS

Rated output power (120 VAC, 60 Hz): Bridge mode, mono:

4 Ohms: 800 W @ 1 kHz, <0.1%

THD

8 Ohms: 650 W @ 1 kHz, <0.1%

THD

Stereo mode, both channels driven:

2 Ohms: 400 W per channel

1 kHz, <0.05% THD

4 Ohms: 325 W per channel

1 kHz, <0.05% THD

8 Ohms: 225 W per channel

1 kHz, <0.05% THD

Minimum load impedance:

Stereo mode: 2 Ohms

Bridge mode: 4 Ohms

Frequency response:

10 Hz to 50 kHz; +0‚ -1 dB, 4 Ohms @ 1 W

Power bandwidth:

15 Hz to 50 kHz; +0‚ -1 dB @ rated, 4 Ohms

Total harmonic distortion:

Stereo mode, both channels driven <0.1% @ 500 W per channel from 20 Hz to 20 kHz

Voltage gain:

Input attenuator set @ FCW 31 dB, stereo mode, 4 Ohms, 1 kHz

38 dB, bridge mode, 8 Ohms,

1 kHz

Crosstalk:

>-75 dB @ 1 kHz @ rated power, 8 Ohms

Crossover:

Fourth order state variable filters:

24dB/Octave Frequency range:

40Hz to 300 Hz

Hum and noise:

Stereo mode, both channels driven below rated output power,

4 Ohms,

>100 dB (30 kHz BW, unweighted)

Slew rate:

Stereo mode, each channel >20V/us

Damping factor:

>250 @ 8 Ohms, 20 Hz to 1 kHz

Phase response:

Stereo mode, 4 Ohms @ rated power

20 Hz leading waveform: <-16.5˚

20 kHz lagging waveform: <+17.5˚

Input sensitivity:

Input attenuator set @ FCW

1.0V @ rated power, 4 Ohms, 1 kHz

Input impedance:

Input attenuator set @ FCW 20 k Ohms, balanced

Cooling:

One front panel, temperature dependant, variable speed DC fan

Controls:

Two front panel attenuators‚ rear panel mode switch‚ rear panel DDT defeat switch, function switch per channel, adjustable low cut filter per channel, low cut filter bypass switch per channel, adjustable subwoofer crossover per channel

Indicator LEDs:

Two DDT, two active status, two DC protect, two over-temperature, two ten-segment signal displays

Protection:

Clipping, short-circuit, thermal overload, DC, turn-on burst, incorrect loads

Connectors:

Combination XLR and 1/4"

(6.3 mm) phone input, Speakon® and binding post speaker output 1/4" (6.3 mm), high pass or full range patch connector per channel, 1/4" (6.3 mm) low pass patch connector per channel, 15 amp IEC mains connectors

Construction:

16 ga. steel with cast aluminum front panel and cast handles

Dimensions (H x W x D):

3.5" x 19" 17.5"

(8.9 cm x 48.3 cm x 44.5 cm)

Net weight:

33.4 lbs (15.2 kg)

Gross Weight:

45.5 lbs (20.6 kg)

2 Ohms stereo mode and 4 Ohms bridge mode power is time limited by magnetic circuit breaker

45