Peerless Industries HDS200 Selecting Input and Output Port, Peer-to-Peer Direct LAN Connection

Selecting Input and Output Port

There are two ways to select input and output sources on the HD Flow Transmitter and Receiver:

1.Using the provided Remote

•Transmitter - Press the desired input while pointing the remote at the Transmitter unit.

•Receiver - Press the desired output while pointing the remote at the Receiver.

2.Using the Power/Source Selection Button

•Transmitter / Receiver - To toggle between inputs press the Power/Source Selection Button on the unit itself.

Notes:

1.Audio and video sources will switch simultaneously whether using the remote or Power/Source Selection Button.

2.Independent audio switching is only allowed for AV and PC audio.

3.Inputs on the Transmitter and Receiver can be switched by pointing the remote at the Transmitter or Receiver ONLY if the connection between Transmitter and Receiver has been established, Link Indicator Light on.

If the connection between Transmitter and Receiver has not been established, the inputs need to be selected at the location of each unit using either of the above input and output selection methods.

Peer-to-Peer and Multicast LAN (wired) Mode Installation

LAN Connection Through Router

Peer-to-Peer Direct LAN Connection

Step 1

Connect the LAN cable between the RJ45 jack on the Transmitter and Receiver. The green light at the connector will turn on solid.

Step 2

With the system running (Power/Link Indicator Light solid and input and output Indicator Lights

solid), point the remote at the Receiver, press and hold the LAN button for 5 seconds until all the indicator lights start flashing on both the Transmitter and the Receiver.

Note: The video and audio will be lost during this process.

Step 3

Peer-To-Peer

Direct Lan

Connection

Allow the HD Flow Pro Wireless Multimedia Kit to re-start. Do not remove power, reset, or use the remote while the system is restarting. Restart of the HD Flow Pro Wireless Multimedia Kit may take up to 2 minutes.

Step 4

Once the HD Flow Pro Wireless Multimedia Kit has restarted, check the LAN connection indicator light on the back of the unit. The indicator lights on both the Transmitter and Receiver should be blinking rapidly. The WiFi indicator lights on the front of both the Transmitter and the Receiver will be solid.

23 of 36 ISSUED: 07-24-12 SHEET #: 180-9023-1