Q.Can the HD Flow Pro Wireless Multimedia Kit be set to default to a specific input/output if the unit is turned off or power is lost?
A.Yes, the HD Flow Pro Wireless Multimedia Kit can be set to desired input and output ports via a programming page that can be accessed by using LAN programming. Please visit http://www.hdflow.
Q.What function does the RJ45 (LAN) port support?
A.The RJ45(LAN) port is used for hard wired LAN mode, and allows HD Flow Pro Wireless Multimedia Kit programming.
Q.If the units are configured to LAN mode, is a straight through or a crossover cable used?
A.In LAN mode the CAT5e/6 cable is a
Q.What is the USB port used for?
A.The USB port is used to upgrade firmware or to do Multicast programming.
Q.Why are there separate Video and Audio buttons on the remote control?
A.The separate AV buttons exist to allow the pairing up of different analog audio sources with any video signal. Note: different digital audio sources cannot be mixed.
Q.How can the HD Flow Pro Wireless Multimedia Kit be put in Standby Mode?
A.The HD Flow Pro Wireless Multimedia Kit is put into Standby Mode by pressing the power button on the remote control or on either the Transmitter or Receiver.
Q.How do I turn off the HD Flow Pro Wireless Multimedia Kit?
A.The HD Flow Pro Wireless Multimedia Kit can be completely turned off by pressing the Power/Source Selection Button for 8+ seconds. This has to be done for each unit individually.
29 of 36 | ISSUED: |
