Peerless Industries HDS200 user manual Indicator Lights Decoded, Transmitter/Receiver, Step

Step 5

Under the heading “Streaming I/F” use the pull down menu to change WiFi to LAN.

Step 6

Enter the proper IP address, for the unit being set up, based on the network's domain.

Step 7

Once all the settings have been entered click the Submit button at the bottom of the form. Keep clicking on the Submit button until you see confirmation "System configurations are changed", as below:

Step 8

After submitting the information and receiving confirmation it is MANDATORY to click on Save Changes, located in the left-hand navigation bar to ensure that your programming will be saved. Once clicking on Save Changes, you will be prompted to save your system configurations. Confirm that you would like to save them by clicking the Save button. You will be prompted again to make sure you want to save these changes. Confirm that you would like to save them by clicking the Save button again.

Indicator Lights Decoded

Transmitter/Receiver

•Power/Link Indicator Light

ºRapid Flashing – Switching from Wireless to LAN or from LAN to Wireless connection or performing firmware update.

ºFlashing – Units are booting and establishing a secure connection for AV transfer.

ºSolid – Successful connection has been established between Transmitter and Receiver(s).

25 of 36 ISSUED: 07-24-12 SHEET #: 180-9023-1