Pelco C3407M-D manual Camera Module, Module Removal

Camera Module

The ICS150-CW Series Camclosure camera module includes the camera, camera bracket, and heater board. To perform most camera adjustments, you must remove the module from the back box.

Use the following instructions to remove and reinstall the camera module.

WARNING: Heater elements could be hot! When camera power is on, use caution when adjusting the camera. This applies to all models.

MODULE REMOVAL

To remove the camera module from the back box:

1. Gently squeeze the bracket and pull the module out of the back box (refer to Figure 5).

BRACKET

Figure 5. Camera Module Bracket

10 C3407M-D (1/07)