4S DEEP ELECTRICAL BOX
NOTE: You should install the camera module into the back box before installing the back box into the surface. When installing the back box into the surface, rotate the camera module to access the mounting holes. Refer to Camera Module on page 10 for more information.
1.Attach the supplied adapter plate to the 4S box with two supplied
2.Pull video and power wires to the ceiling tile.
3.Connect the video cable/wires:
BNC: Connect the BNC connector from the unit to a mating BNC connector.
Twisted Pair (UTP): Blue wire = Video +
Gray wire = Video -
4. Connect the power wires.
Voltage | Red Wire | Black Wire |
12 VDC | + | Ground |
24 VAC | ~ | ~ |
AC operation only: If you are wiring more than one Camclosure integrated camera system to the same transformer, connect one side of the transformer to the red wire on all units, and connect the other side of the transformer to the black wire on all units. Failure to connect all of the units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
5. Attach the back box to the adapter plate with four supplied
4S DEEP ELECTRICAL BOX
HEAD SCREW
(SUPPLIED)
WALL OR CEILING
ADAPTER PLATE
BACK BOX
Figure 4. 4S Deep Electrical Box Installation
9 |
