SUSPENDED CEILING
NOTE: You should install the camera module into the back box before installing the back box into the surface. When installing the back box into the surface, rotate the camera module to access the mounting holes. Refer to Camera Module on page 10 for more information.
1.Pull video and power wires to the ceiling tile.
2.Mount the unit to the ceiling tile (refer to Figure 3):
a.Remove the ceiling tile from the ceiling.
b.Cut a hole 3.5 inches (9 cm) in diameter in the ceiling tile. Use the supplied adapter plate as a template. Punch four screw holes in the ceiling tile.
c.Attach the back box to the ceiling tile and adapter plate with four supplied
d.Reinstall the ceiling tile with the unit.
| ADAPTER PLATE | |
| CEILING TILE | |
| ||
PHILLIPS FLAT | BACK BOX | |
HEAD SCREWS | ||
| ||
(SUPPLIED) |
|
Figure 3. Ceiling Tile Installation
3.Remove an adjacent ceiling tile.
4.Connect the video cable/wires:
BNC: Connect the BNC connector from the unit to a mating BNC connector.
Twisted Pair (UTP): Blue wire = Video +
Gray wire = Video -
5. Connect the power wires.
Voltage | Red Wire | Black Wire |
12 VDC | + | Ground |
24 VAC | ~ | ~ |
AC operation only: If you are wiring more than one Camclosure integrated camera system to the same transformer, connect one side of the transformer to the red wire on all units, and connect the other side of the transformer to the black wire on all units. Failure to connect all of the units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
8 |
