Pelco C3407M-D manual Install Dome and Trim Ring

Install Dome and Trim Ring

1.Adjust the dome liner if installed (refer to Figure 12):

a.Align the screw holes in the trim ring with those in the back box to identify the proper dome liner position.

b.Loosen the three Phillips screws located in the trim ring.

c.Insert the blade of a standard screwdriver in one of the adjustment grooves. Rotate the dome liner to position the viewing window over the camera lens.

d.Tighten the three Phillips screws to lock the dome liner in place.

ADJUSTMENT

GROOVE

DOME LINER

LOOSEN SCREWS

Figure 12. Dome Liner Adjustment

2.Place the trim ring onto the back box.

3.Tighten the tamper-resistant screws through the trim ring into the back box. Use the supplied 1/8-inch hollow screwdriver bit. Note that the screws are installed at an angle.

C3407M-D (1/07) 17