C613M-A (5/05) 5
Description
The SP04-140 is a special version of the single-input NET5301T video encoder. It is a high-performance, dual-stream, dual-input video encoding
unit. Its main function is to convert live analog video from two cameras into dual MPEG-4 video streams. It transmits these streams over an
Ethernet network to other Endura
™
system components. Then these streams can be recorded on an Endura NVR5100 Series network video
recorder or decoded by the following Endura components:
• NET5301R video decoder: Converts up to 4 video streams for display or recording on an analog device.
• WS5050 workstation: Converts up to 16 video streams for display on a computer monitor.
• VCD5000 video console display: Converts up to 64 video streams (depending on model) for display or recording on an analog device.
NOTE:
The front panel of the SP04-140 shows NET5301T as the model. However, the special number appears on the product serial number label
on the unit’s bottom panel.
The SP04-140 incorporates EnduraView
™
video optimization technology to select the best image quality and frame rate for the target Endura
product (decoder, workstation, console), all without affecting the system recording rate. For example, the unit selects a high rate and quality
setting for recording and alarm conditions; it selects a lower rate for simple monitoring.
The SP04-140 can be configured for three alarm inputs and one relay output. When an alarm event is triggered, the unit can send a message to
an operator, trigger a relay, and implement video recording.
The unit also supports activity detection. You can configure up to four activity zones. When the SP04-140 detects activity in any of these areas, it
can trigger an alarm event.
The video encoder supports half-duplex, bidirectional audio over the network. The system operator (security personnel) can see and hear the
person.
All Endura products support Pelco D and Coaxitron
®
protocols. As a result, the SP04-140 supports control of remote peripherals such as pan/tilt/zoom
(PTZ) cameras.
Before You Begin
Endura is a network system that requires a continuous amount of bandwidth to transmit true, live video. Therefore, always include your network
administrator when planning and installing Endura components.
You will also need the following:
• Pelco-approved Endura certification
• Power source
• One or two NTSC or PAL (fixed or PTZ) cameras
• Microphone and speaker (if using audio)
• Small flat-tip screwdriver (if connecting camera control, relay, or alarms)
• Access to an Endura network
NOTE:
Since power requirements vary by installation, the SP04-140 does not include an individual power supply. You can purchase the optional
NET5301PS single-unit power supply from Pelco. Refer to
Connecting Power
for more information on supplying power to the SP04-140.
PARTS LIST
Qty Description
1 SP04-140 dual-input video encoder
1 16-pin terminal block
1Two-pin power terminal block
1 SP04-140 Installation manual
1 Pelco badge rotation sticker