Pelco C540M (6/98) 3.2.2To Leave Setup Mode, 3.2.3Creating a Setup PIN, Creating a Define PIN

3.2.2To Leave Setup Mode

1.Select and return DIP switch 2 to the OFF position.

3.2.3Creating a Setup PIN

ADVANCE SETUP 4

>SETUP PIN ****

CONFIRM ****

DEFINE PIN ****

CONFIRM ****

NOTE: A PIN is required to enter SETUP mode.

The factory settings for the CM9760-KBD include the default password 1234. An alternative password can be defined as follows:

1.While in setup mode, use and/or to locate Advance Setup 4.

2.Select , type a four-digit PIN, and select once again.

3.Select Confirm, retype the PIN, and select once again.

3.2.4 Creating a Define PIN

NOTE: A PIN is required to use the features that are accessible via the DEFINE menu.

The factory settings for the CM9760-KBD include the default password, 1234. An alternative password can be defined as follows:

1.In setup mode, use and/or to locate Advance Setup 4.

2.Select Define PIN using and/or .

3.Select , type a four-digit PIN, and select once again.

4.Select Confirm, retype the PIN, and select once again.

3.2.5 Calibrating the Joystick

JOYSTICK SETUP

XXX

XXX (XXX, XXX) XXX

XXX

To make the joystick operational, proceed as follows:

1.In setup mode, select .

2.With the joystick in the central default position, select .

3.Move the joystick fully left, and select .

4.Move the joystick fully right, and select .

5.Move the joystick fully down, and select .

6.Move the joystick fully up, and select .

7.Save the joystick configuration by selecting .

8.Select .

3.2.6 Adjusting the Display Brightness

While in setup mode, the brightness of the display can be adjusted. This is done by

LCD BRIGHTNESS SETUP
selecting	, after which the display may be brightened or darkened using

NOTE: The display brightness can		or	. When satisfied with the brightness setting, press	followed by	.
also be adjusted by selecting	from

the define sub-menu. The define sub-

menu is produced by selecting .

Pelco Manual C540M (6/98) 11