STEP 4
You must now inform the Door Controller of the Site Code of the Access Passes supplied.
The Site Code is always stored in Slot No. 01.
The Site Code is always a 5 digit number.
Check the Access Pass Information Sheet delivered with the Access Passes. It will tell you the Site Code of the Access Passes delivered.
*
Example: Site Code = 45801
After a beep enter on the TELPRO:
A sharp beep confirms that you have correctly entered the Site Code. Programming mode beep - every 4 seconds - resumes.
*KBP Proximity Cards have the full site code printed on each card.
STEP 5
You must now inform the Door Controller of the Access Pass Holder Numbers supplied.
Check the Access Pass Information Sheet delivered with the Access Passes. It will tell you which Holder Numbers we have supplied.
Example: 150no. Access Passes Supplied | HOLDER NUMBERS |
After a beep enter on the TELPRO:
*See Tip Wizard on page 13
A series of 3no. beeps followed by a sharper beep confirms that you have correctly entered the Holder Numbers. Programming mode beep - every 4 seconds - resumes.
STEP 6
Turn off programming switch SW1 in the Door Controller. You have successfully programmed the system. The Access Passes should now all work.
ADVANCED PROGRAMMING
In the following examples of programming we are assuming that the Master Code = 19388. This is purely for demonstration purposes. When programming for real, you must enter the Master Code that you chose and set when the system was installed.
Example A: Block Loading/Validation of Access Passes.
You have just received an additional 25no. Access Passes for the system. Holder Numbers 151- 175.
Enter the Master Code 19388 on the TELPRO. Beeps every 4 seconds indicate that you have accessed Programming Mode.
After a beep enter on the TELPRO:
A series of 3no. beeps followed by a sharper beep confirms that you have correctly entered the Holder Numbers. Programming mode beep - every 4 seconds - resumes.
Example B: Deletion of 1no. Access Pass
You have just been informed that Alan Jones has lost his Access Pass. Alan was Holder Number 074. You have to delete it immediately to restore system security. Enter the Master Code 19388 on the TELPRO. Beeps every 4 seconds indicate that you have accessed Programming Mode.
10
