Pelco ECP290, ECP190 manual Access Control Modules with integral Infra-Red

Programming Stand-Alone Access Control Systems using TELPRO™ Programmer.

®

TELPRO™ PROGRAMMER

The TELPRO™ Programmer is a handheld keypad used for programming Noralsy® stand-alone access control systems.

Installation companies only ever need 1no. TELPRO™ Programmer.

TELPRO™ can be used on any system provided, of course, the Master Code (also referred to as the Engineer Code) which grants access into programming mode is known or, access to the ECP Door Controller itself is available.

The final customer only needs a TELPRO™ unit if they wish to effect programming themselves.

Access Control Modules with integral Infra-Red

MLP3 Proximity

The TELPRO™ Programmer can be used as a wirefree infra-red programmer. Simply point at the reader/receiver module to program.

MIR Infra-Red

TELPRO™

Programmer

Access Control Modules, Readers, Receivers without integral Infra-Red

The TELPRO™ Programmer is supplied with a connector cable. Simply connect to ECP Door Controller to program.

TELPRO™

Programmer

Dim:

120L x 60W x 25D

ECP190

ECP290

ECP100

ECP200

LTP03	LB20 Swipe Card
Office Proximity Reader	MILB Card Reader

LHF

Radio receiver

If the entrance or door panel includes a MICAM/MICIM Keypad Module connected to the ECP Door Controller, all programming can be effected directly via the MICAM/MICIM Keypad ie. TELPRO™ Programmer would not be required. You would also then have the option of having keypad access codes.

All measurements in millimetres. 7