Programming using TELPROas a remote wire-free programmer.

Remote Programming Range:

Infra-Red Receiver

20 cms - 5 metres

Proximity Reader

5 cms - 10 cms

How to use the TELPRO:

 

Important:

Each press of a button is confirmed (as received) by the reader/receiver by a single beep. Press the TELPRObuttons gently.

Flick TELPRO switch to ON - Red LED on the right must light up.

(Remember to turn unit off when finished)

Point TELPRO at the reader/receiver.

Dimensions (mm): 120L x 60W x 25D

Enter the Master Code and wait for the reader/receiver to start beeping every 4 seconds

OR

Flick Programming Switch SW1 and wait for the reader/receiver to start beeping every 4 seconds (Remember to turn off the programming switch SW1 when you have finished programming).

Follow programming instructions

Note: An incorrect programming operation is signalled by a series of 3 beeps.

Programming using TELPROas a hard-wired programmer

How to use the TELPRO as a hard wired unit:

Insert the jack connection into the top of the TELPRO unit.

Plug the connector terminal onto J5 on ECP Door Controller.

Enter the Master Code and wait for the unit

to start beeping every 4 seconds

OR

Flick Programming Switch SW1 and wait for the unit

to start beeping every 4 seconds

(Remember to turn off the programming switch SW1

when you have finished programming)

Follow programming instructions.

ECP290/ECP200

J5 = Access Point 1

J6 = Access Point 2

Important:

Each press of a button is confirmed (as received) by the Door Controller by a single beep.

Press the TELPRObuttons gently.

8

Page 8
Image 8
Pelco ECP190, ECP290 manual Programming using Telpro as a remote wire-free programmer