C2655M-A (10/08) 17
5. Apply a matching colored sticker (red or yellow) next to the USB connector on the NET5300B rear panel. This identifies the USB cable (red
or yellow) that should be connected to this NET5308T-EXP.
Figure 13. Connecting an NET5308T-EXP to a NET5300B
6. If necessary, repeat steps 1–5 for other NET5308T-EXP encoders.
7. Start the NET5308T-EXP.
8. Start the NET5300B (refer to the NET5300B Installation manual for more information).
When the NET5308T-EXP is first started, the unit status light blinks green until the NET5300B recognizes it and puts it into service.
CONNECTING VIDEO INPUT AND OUTPUT DEVICESThe NET5308T-EXP offers both analog video input and looping video output for eight video devices.
Figure 14. Video Inputs and Outputs
Before installing the NET5308T-EXP, make sure the distance from the unit to each video device is less than the maximum distance for the coaxial
cable. Refer to TableB for maximum video coaxial cable distances.
NET5300B
APPLY
RED LABEL
APPLY
YELLOW LABEL
A5 A6 A7 A8
SEC
NO
N
NC
NO
N
NC
APPLY
RED LABEL
NET5308T-EXP #1
USB “B”
CONNECTOR
A5 A6 A7 A8
SEC
NO
N
NC
NO
N
NC
APPLY
YELLOW LABEL
NET5308T-EXP #2
USB “B”
CONNECTOR
USB “A” CONNECTOR
RED USB CABLE
YELLOW USB CABLE
A1 A2 A3 A4 A5 A6 A7 A8
SEC
1234 5678
100-200 VAC - 50/60 HZ
0.7 AMP
NO
C
NC
NO
C
NC
NO
C
NC
NO
C
NC
MODEL
FREQ
50/60HZ
Sample Text
AMPS
VOLTS
Sample Text
REV
Sample Text
03267-39-0020
MFG BY PELCO, CLOVIS, CA
Model
SN
Audio/Video Apparatus
91KK
MADE IN USA