![](/images/new-backgrounds/1055937/5593737x1.webp)
CONNECTING LOOPING VIDEO
The
To use looping video:
1.Connect a coaxial cable to the video out connector on the rear panel.
NOTE: You may have to use a BNC installation tool to connect coaxial cables to the rear panel.
2.Connect the other end of the coaxial cable to the analog device.
3.After installation, use the Endura workstation to disable video termination for the video channel.
4.If looping video to additional devices, disable video termination
NOTES:
•If you do not terminate the video signal at the last device in the series, ghosting or other imperfections may appear in the video signal.
•During a power loss, the video termination settings may be lost. As a result, video imperfections may appear on devices that receive looping video from the
CONNECTING AUDIO
The
The unit supports line level inputs. Microphones must be amplified for best results.
MICROPHONES
|
| AUDIO PREAMP |
|
| |
1 | 2 | 3 | 4 |
| A1 |
|
|
|
|
| NO |
|
|
| Model | C | |
|
|
| NO | ||
|
|
|
|
| NC |
|
|
|
|
| C |
|
|
|
|
| NC |
Figure 15. NET5308T-EXP Audio Connections
To implement audio:
1.Make sure your audio input device matches the 1 Vp-p line input level (+4dB, 1.228 V maximum). If the audio source does not match this specification, audio distortion problems may occur.
2.Wire the audio input device to the 3.5 mm monaural audio plug as follows:
Connector Tip | Signal high |
Connector | Common |
Sleeve |
|
3. Insert the audio plug into the audio connector for the video channel on the
19 |