144

Changing the Built-in Flash Discharge Method

You can change the built-in flash discharge method in Wireless Mode. Set in [15. Flash in Wireless Mode] in the [ACustom Setting 3] menu (p.79).

1

On

Discharges the built-in flash.

 

 

 

2

Off

Discharges the built-in flash as a control flash.

 

 

 

HSb (High-speed sync) is not available with the built-in flash.

5

the Using Flash

Wireless Shooting

Using a Combination of the Built-in Flash and an External Flash Unit

1Remove the external flash unit after the channel was set on the camera, and place at the desired location.

2Set the camera flash to rmode, and pop up the built-in flash.

3Confirm that both flashes are fully charged and then take a picture.

Using a Combination of External Flash Units

1Set the wireless mode of the external flash directly connected to the camera to [MASTER] or [CONTROL].

MASTER

Discharges both the flash directly connected to the camera

and the wireless flash unit.

 

 

 

CONTROL

The flash directly connected to the camera is discharged as

a control flash only and does not discharge as main flash.

 

 

 

2On the wireless remote flash unit, set the wireless flash mode to [SLAVE] and set the channel to the same channel as the flash directly connected to the camera. Then, place at the desired location.

3Confirm that both flashes are fully charged and then take a picture.

Shake Reduction is not available in Wireless Mode.