Line Commands 93
Line Service Commands
Set Power-Management Line
slave-ip
The IP address of the TCP/Ethernet Modbus Slave.
uid-range
When Range Mode is Host and you have sequential Modbus Slave IP addresses (for
example, 10.10.10.1, 10.10.10.2, 10.10.10.3, etc.), you can specify a UID range and the
IOLAN will automatically increment the last digit of the configured IP address.
Therefore, you can specify a UID range of 1-100, and the IOLAN will route Master
Modbus messages to all Modbus Slaves with IP addresses of 10.10.10.1 - 10.10.10.100.
Description Configures the power management settings for the line.
User Level Admin
Syntax set power-management line .|<number>|*
[model rps820|rps830|rps1620|rps1630] [name <bar_name>]
set power-management line .|<number>|* plug <1-8|1-16>
[default-state on|off] [name <plug_name>]
[power-up-interval .5|1|2|5|15|30|60|120|180|300]
[serial-line <number>]
Options model
Specify the power bar model, either RPS820, RPS830, RPS1620, RPS1630.
name (power bar name)
Specify a name for the RPS.
plug
Specify the power bar plug number you are configuring.
default-state
Sets the default state of the plug, either on or off. The default is off.
name (plug name)
Specify a name for the plug to make it easier to recognize and manage.
power-up-interval
Specify the amount of time, in seconds, that the power bar will wait before powering up
a plug. This can be useful if you have peripherials that need to be started in a specific
order.
serial-line
Associate a serial line(s) connected to a serial device that is plugged into the power bar
on that plug.