Models BBRN/BBSN Installation & Operation Manual
Digital Temperature Control
C |
F |
SET |
Figure 2. Digital Temperature Controller
To change the Setpoint:
1.Press the SET button for more than 2 seconds.
2.The value of the setpoint will be displayed and the “C” or “F” LED starts blinking.
3.To change the Set value, press the or button within 10 seconds.
4.To memorize the new setpoint value, press the SET key again, or wait 10 seconds.
Adjustments
Changing Door Swing Direction
NOTE: Changing the door swing direction is not advisable if the door is not equipped with a full length handle. Doing so may result in an undesirable handle position..
Hinge Kits
Part No. 67439R: Right Hinging
Part No. 67439L: Left Hinging
Tools Required
1.Support the door in the open position as shown in Figure 3. Remove the hinge pin.
2.Pull door to the side and then lower the door.
3.Remove top and bottom hinge brackets. Retain screws for later use. See Figure 4.
4.Remove the hole plugs from the top and bottom hinge bracket mounting holes (Figure 4). Place the plugs in the holes on the opposite side made vacant by removing the hinges in step 3.
•Large flat head screwdriver
•Regular Phillips head screwdriver
•Hinge Kit from Perlick
•Plastic putty knife
Procedure |
SUPPORT |
Pull door to |
the side then lower door |
Remove hinge pin |
Figure 3. Door Removal
Hinge brackets | Hole plugs |
and mounting |
|
screws |
|
Hinge brackets |
|
and mounting |
|
screws |
|
Figure 4. Hinge Removal
Printed in USA | 6 | 0213 |