The position of the Balanced CD Input switch has no bearing on the balanced output, it only selects which CD input to use. Set the balanced CD input switch to ON only when using the balanced CD input.
Refer to Chapter 13 “Specifications”, for detail on input sensitivity and impedance.
Unbalanced Source Inputs
Accepts a standard single-ended input (RCA) from source components with single-ended analogue outputs. These high quality gold plated sockets are highly conductive, corrosion resistant, and provide less potential for corrosion induced distortion.
Refer to Chapter 13 “Specifications”, for detail on input sensitivity and impedance.
VCR Line Outputs
This single-ended (RCA) output will provide a line level audio signal, suitable for recording, from the selected source input. This output is disconnected when the VCR source input is selected; to prevent any potentially damaging feedback loops.
Tape Line Outputs
This single-ended (RCA) output will provide a line level audio signal, suitable for recording, from the selected source input. This output is disconnected when the Tape source input is selected; to prevent any potentially damaging feedback loops.
Main Output 1
This single-ended (RCA) output is commonly referred to as “Preamp Out”. It will provide the audio signal required to drive virtually any amplifier to full power.
Main Output 2
This single-ended (RCA) output is wired in parallel with Main Output 1 and is useful for supplying signal to another amplifier if bi-amping.
Balanced Outputs
This balanced (XLR) preamplifier output provides the signal required to drive virtually any power amplifier equipped with a balanced input. Connection should be made with high quality cables fitted with XLR connectors.
The position of the balanced CD input switch has no bearing on the balanced output; it only selects which CD input to use. It is not necessary to set this switch to ON when using the balanced outputs.
