
8.Attach feed line mounting clip to pedestal using #8 X 1/2" S.S. machine screw. BE SURE TO ALIGN SCREW TO AVOID STRIPPING THREADED NUTSERT.
9.Remove "Sure Start" Ignitor module from the underside of control panel by unscrewing black ring. Remove rear cover of module and insert a fresh AA alkaline battery into unit (included). Plug the end of the ignitor wire lead to the electronic ignitor module. NOTE: On the
Figure 8 Ignition Module Assembly
NOTE: Replace battery when sparking sound either stops or noticeably slows down or every six months, whichever occurs first. If you are not going to use your grill for more than 30 days, remove the battery. Reinstall when you are ready to use your grill again.
SIDE SHELF ASSEMBLY10.Install the left and right shelf brackets to the lower casting of your barbecue, using the four 1/4 X 20 X 3/4" hex bolts, secure with four 1/4" lock washes and four 1/4" hex nuts to hold each bracket (see Fig. 9). Attach shelf to the brackets by inserting the threaded screws on the shelf through the lower slots on the brackets. Let the shelf hang down. Attach the
Figure 9 | Installing Shelf Bracket |
On portable models, this shelf, in the upright position, is to be used as a handle to move the barbecue around. It is a sturdy handle properly hinged securely into place (see Fig. 10).
Figure 10 | Hinging Shelf |
11.Attach two control valve knobs to end of valve stems located in center of control panel. White mark should be pointing up to the OFF position.
FINISH ASSEMBLY1.Be sure to remove plastic protective film. Place "Flare Guard" rock grate so that feet (bent ends) face down.
2.Place ceramic "Moon Rok II" on rock grate by evenly placing side by side. DO NOT COVER HOLES IN THE "FLARE GUARD" ROCK GRATES. Do not put more than one layer of rock on the grates (see Fig. 11).
17