Figure 11 Proper placement of rock grates and "Moon Rok II"

3.Place cooking grids in casting, "VARI GRID" cooking grids can be placed with close tines together in the middle or separated to the outside of the casting whichever better suits your grilling needs

(see Fig. 12).

Figure 12 Placement of Cooking Grids

4.Place the warming rack in slots on top of the lower casting.

5.Place lid on lower casting. Insert hinge pins through top lid casting, then through pre-drilled hole in lower casting and attach cotter pins through hole in hinge pins to secure top to bottom casting

(see Fig. 13).

6.Attach twin lid side "Stay Cool" handles using 5/16" X 3/4" bolt and star washer, tighten securely.

7.Slide grease tray into slot at top rear of pedestal. Tray must be tilted up before inserting in.

8.If you purchased a LC base kit you will need to attach the tank strap to the back of the cart. Attach as follows: Screw one of the #8 X 1/2" S.S. screws into the left hand nut that is pre-attached at the midpoint of the back of the pedestal so that it remains 1/4" out. Push the other #8 X 1/2" S.S. screw through tank strap. Screw this assembly into the pre-attached nut at the right hand side of the midpoint of pedestal. Tighten so that tank strap can still be raised up.

BE SURE TO START THESE SCREWS SLOWLY AND CAREFULLY TO ENSURE YOU DO NOT CROSS THREAD THE NUT OR SCREW.

CONNECTING GAS SUPPLY

1.If you have a portable model, connect 3/8" X 3/8" flare elbow fitting from either the 16" or 20" LP hose or the 12 foot gas hose to flare fitting on the feedline at back of pedestal (see Figs.14,15, &16). This is a brass to brass connection. DO NOT USE ANY PIPE

SEALER. DO NOT CROSS THREAD. TIGHTEN SECURELY.

 

 

Figure 14

Brass Elbow

 

 

2. If you have natural gas, connect your gas supply to

 

 

the feedline ending in a 3/8" female flare fitting at the

Figure 13

Hinge Pins/Cotter Pins

back of the pedestal with an approved connector with

shut off valve at a natural gas stub.

 

 

18