BASIC TELEVISION CONNECTION
ANTENNA CONNECTION
·Connect the antenna or RF cable signal to the 75 ohm RF 'F' connector socket located on the TV's rear jack panel.
MAINS CONNECTION
·Ensure that the mains voltage and frequency are correct. Please refer to the product labelling and documentation.
Note : The power button on the front panel does not disconnect the television from the AC mains. It toggles the TV between on and standby mode. To completely turn off the AC mains power, you mu st unplug the AC mains plugs from the wall socket.
POWER
FORMAT CLOCK SLEEP GUIDE
AV | SAP | CC | INFO |
AUTO |
| A/D | AUTO |
SOUND |
| PICTURE |
MENUOK
MUTE
VOLCH
1 2 3
4 5 6
7 8 9
A/CH 0
SWITCHING ON THE SET
REMOTE STANDBY POWER
·Press the power button on the TV's front panel or on the remote control to switch the TV set on.
Note : If the TV is in commercial mode, it might not respond to the front panel or the remote control. Please refer to the section on TV Installation and TV Setup Menu in this documentation for more informaton.
FRONT PANEL STANDBY POWER
(EXAMPLE)
USE & CARE OF REMOTE CONTROL
To load the supp lied batteries into the remote control ;
-Remove the battery compartment lid from the back of the remote control.
-Insert two
the positive + and negative - polarity line up correctly as indicated inside the case.
- Reattach the battery compartment lid.
Note : Always remove batteries from the remote control if it is not used for a long period of time. This is to prevent damage to the remote control due to battery leakage.
6
