Dukane 8918, 8943 user manual Adjusting the position, Correcting the keystone distortions

Operating

Adjusting the position

1. Press the POSITION button on the remote control. The “POSITION” indication will appear on the screen.

2. Use the cursor buttons ▲/▼/◄/► to adjust the picture position.

PUSH ENTER

PAGE UP		PAGE DOWN
ESC	MENU	RESET
POSITION	AUTO
MAGNIFY	MY BUTTON	VOLUME

When you want to reset the operation, press the RESET button on the remote control during the operation.

To complete this operation, press the POSITION button again. Even if you do not do anything, the dialog will automatically disappear after a few seconds.

●When this function is performed on a video signal, s-video signal or component video signal, some image such as an extra-line may appear at outside of the picture.

●When this function is performed on a video signal, s-video signal, or component video signal of 525i (480i) or 625i (576i), the range of this adjustment depends on the OVER SCAN in IMAGE menu (29) setting. It is not possible to adjust when the OVER SCAN is set to 10.

Correcting the keystone distortions

1.	Press the KEYSTONE button on the
			-';5610'
	remote control. A dialog will appear on the
			#761		':'%76'
				
screen to aid you in correcting the distortion.		/#07#.				
2.	Use the cursor buttons ▲/▼ to select AUTO or
	MANUAL operation, and press the button ► to perform the following.

1)AUTO executes automatic vertical keystone correction.

2)Manual displays a dialog for keystone correction.

Use the cursor buttons ◄/► to select the direction to correct ( or ) then use the buttons ▲/▼ for adjustment.

To close the dialog and complete this operation, press the KEYSTONE button again. Even if you don’t do anything, the dialog will automatically disappear after a few seconds.

MAGNIFY	MY BUTTON	VOLUME
ON	1
		MUTE
OFF	2

FREEZE KEYSTONE SEARCH

 

-';5610'

●The adjustable range of this function will vary among inputs. For some input, this function may not work well.

●When V:INVERT or H&V:INVERT is selected to the MIRROR item in the

SETUP menu, if the projector screen is inclined or angled downward, this function may not work correctly.

●When the zoom adjustment is set to the TELE (telephoto focus), this function may be excessive. This function should be used when the zoom adjustment is set to the full WIDE (wide-angle focus) whenever possible.

●When the projector is placed on the level (about ±3°), this function may not work.

●When the projector is inclined to near ±30 degree or over, this function may not work well.

●When the vertical lens shift is not set fully upward (not set fully downward for the optional lens type FL-601 only (45)), this function may not work well.

●When the horizontal lens shift is not set to the center, this function may not work well.

●This function will be unavailable when Transition Detector is on (51).

20