Dukane 8918, 8943 user manual Command Control via the Network, Command Control Settings 9

Command Control via the Network

Command Control via the Network

You can configure and control the projector via the network using RS-232C commands.

Communication Port

The following two ports are assigned for the command control. TCP #23

TCP #9715

NOTE • Command control is not available via communication port (TCP #9716) that is used for the e-SHOT transmission function.

Command Control Settings (9)

Configure the following items from a web browser when command control is used.

Example: If the IP address of the projector is set to 192.168.1.10:

1)Enter [https://192.168.1.10] into the address bar of the web browser.

2)Enter the Administrator ID and Password and click [Logon].

3)Click [Port settings] on the main menu.

4)Click the [Enable] check box to open [Network Control Port (Port: 23)] to use

TCP #23. Click the [Enable] check box for the [Authentication] setting when authentication is required, otherwise clear the check box.

5)Click the [Enable] check box to open [Network Control Port (Port: 9715)] to use TCP #9715. Click the [Enable] check box for the [Authentication] setting when authentication is required, otherwise clear the check box.

6)Click the [Apply] button to save the settings.

34