Dukane 8943, 8918 user manual Network Menu

NETWORK Menu

NETWORK Menu

Consult with your network administrator before connecting to an existing access point on your network. Incorrect network settings on this projector may cause trouble on the network.

Select “NETWORK” from the main menu to access the following functions.

Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table.

/'07=4) $?		5'.'%6
2+%674'	&*%2	674010
+/#)'	+2#&&4'55
+0276	57$0'6/#5-
5'672	&'(#7.6)#6'9#;
#7&+1	6+/'&+(('4'0%'
5%4''0	'#0&6+/'
126+10	G5*16
0'6914-	+0(14/#6+10
'#5;/'07	5'48+%'

NOTE • The factory default setting for DHCP is “TURN ON”. There is no need to set

up [DHCP], [IP ADDRESS], [SUBNET MASK] or [DEFAULT GATEWAY] if your network

has DHCP enabled. ( User’s Manual - Network Functions)

•If you are not utilizing SNTP ( User’s Manual - Network Functions), then you must set the DATE AND TIME during the initial installation. Please refer to the item DATE AND TIME on the following list.

Item	Description
DHCP	DHCP TURN ON/TURN OFF:	&*%2
	Use the ▲/▼ buttons to turn DHCP on/off	674010
(Dynamic Host		67401((
	TURN ON  TURN OFF
Configuration
	Select TURN OFF when the network does not have DHCP
Protocol)
	enabled.
	Entering the IP ADDRESS :
	Use the ▲/▼/◄/► buttons to enter the IP	192. 168. 1. 254
	ADDRESS. This function can only be used	IP ADDRESS
IP ADDRESS	when DHCP is set to “TURN OFF”.

•The IP ADDRESS is the number that identifies this projector on the network. You cannot have two devices with the same IP ADDRESS on the same network.

	Entering the SUBNET MASK :
SUBNET MASK	Use the ▲/▼/◄/► buttons to enter the	255. 255. 255. 0
	same SUBNET MASK used by your PC.	SUBNET MASK
	This function can only be used when DHCP
	is set to “TURN OFF”.
	Entering the DEFAULT GATEWAY :
DEFAULT	Use the ▲/▼/◄/► buttons to enter the	0. 0. 0. 0
	DEFAULT GATEWAY (a node on a computor	DEFAULT GATEWAY
GATEWAY	network that serves as an access point to

another network) address.This function can only be used when DHCP is set to “TURN OFF”.

(continued on next page)

53