TV Setup
Speakers General Source Decoder Setup 
Test tone 
Balance 
Centre volume 
Surround L volume 
Surround R volume 
Wireless surround 
To front 
To surround 
Subwoofer 
Auto surround 
The Setup menu contains items that control the settings of the TV’s functions, features, services and peripherals you may have connected.
The Speakers menu reflects the
The General menu allows you to change settings that will typically be accessed only occasionally. The Source menu allows you to select a source. The Decoder menu allows you to define one or more programme numbers as decoder programme numbers.
Speakers
Your TV is equipped with integrated front left, right and centre loudspeakers, capable of reproducing Stereo and Dolby 3 stereo modes.
For Hall, full Dolby Pro Logic II and Dolby Digital surround sound you should use the two amplified rear surround speakers.
Depending on the output and Surround mode (see Main menu,TV, Sound, Surround mode, p. 13) selected, some menu items may be greyed out and are not selectable.
Test tone controls
The menu item Test tone enables you to balance the volume levels of the speakers.
&Select Test tone and press the cursor right.
éOnce turned on, the Test Tone will circulate through the left, centre, right speakers and both rear surround speakers (if present).
“Press the cursor up/down to select the desired speaker for individual volume level adjustment.
‘Press the cursor left/right to adjust the volume level.
Wireless Surround
The system has already been configured in the factory to work properly.
In rare circumstances, interference from external RF (wireless) equipment such as RF headphones, mobile phones or remote controls for lights, may occur.
Then it may be necessary to shift to another wireless channel.
Use the cursor left/right, up/down to select another channel.
Important:Always be sure that the wireless receiver box and the Wireless Surround setting are switched to the same transmitting channel. Otherwise no sound or only a distorted sound will be heard on the surround speakers.
To avoid interfered picture the wireless transmitter might be automatically switched off.
In rare cases, when no RF surround sound is possible or when there is too much interference, use the wired back up solution with a 3.5 mm stereo jack. In this case select Off in the Wireless surround menu item. See Connect Peripheral equipment,Wired rear loudspeakers, p. 28.
To front / To surround
Select To front or To surround and then select the distance between the TV or the rear surround speakers and the place you sit to watch TV.
Subwoofer
Select if you want to use the internal subwoofer or if you installed an external one. See Connect Peripheral Equipment, Connect extra subwoofer, p. 28.
Auto Surround
Sometimes the broadcaster transmits special signals for Surround Sound encoded programmes.
The TV automatically switches to the best surround sound mode when Auto Surround is switched On. However it is possible to overwrite this setting.
9
