Wireless Surround speaker system
WIRELESS MODULE
®
| 13 V DC in |
| ||
| AUDIO in | 4 | /15W | |
| (TV) | |||
|
|
| ||
| 2.8V RMS | R | L | |
14 | 41 | |||
|
| |||
23 | 32 |
|
| |
4 1 2
3
2
75
ANTENNA
FM RADIO
Wireless transmitter module
•Switch the TV off with the power switch.
•Attach the wireless module to the back of the TV as shown.
•Connect the attached cable to the wireless module connector.
•Switch the TV on.
Surround loudspeakers
•There are two NXT SurfaceSound® * surround loudspeakers which have to be connected to the wireless receiver box 2 R and L.
If one of the connection cables is too short the 4 m extension cable supplied can be used.Table stands as well as wall supports are supplied.
•The Surround sound loudspeakers can be located behind or to either side of the listener.The front of the loudspeakers do not have to face the listener.The distance between the TV and the surround speakers should not exceed 15 m.
Wireless receiver box
Connect the 13V DC adaptor supplied to the 13V DC IN 1 input at the bottom of the receiver box. Connect the adaptor to the mains.
The slide channel switch 3 has been set default to channel 1 in the factory.
The indicator on the receiver box shows that the speakers are in standby. During sound transmission the indicator turns to green.
The system has already been configured in the factory to work properly. In rare circumstances, interference from external RF (wireless) equipments such as RF headphones, mobile phones or remote controls for lights, may occur.Then it may be necessary to shift to another wireless channel. Important:Always be sure that the Wireless receiver box and the Wireless Surround settings (see p. 9) are switched to the same transmitting channel.
In rare cases, when no RF surround sound is possible, or when there is too much interference, use the wired back up solution. See Wired rear loudspeakers, p. 28.
FM Wire Antenna connection
Connect the supplied FM wire antenna to the FM RADIO ANTENNA 75 ø connector at the back of the TV. Adjust the position of the FM antenna for the best reception.
Note: for better FM stereo reception, connect an outdoor FM antenna or cable antenna to the FM RADIO ANTENNA 75 ø connector using a 75 ø coaxial wire.
* | NXT® is a trademark of New Transducers Limited |
| 3 |
