Philips 37MD359B user manual  Supplied Accessories,  Attaching the Stand, Batteries AAA x, Side

INTRODUCTION

Supplied Accessories

user manual	quick start guide	remote control	registration card	AC power cord
(1EMN25079)	(1EMN25081)	(NF801UD)	(1EMN24699)	(WAV0162LW001)

batteries (AAA x 2)

AAA

AAA

screw kit for attaching the stand (1ESA20208)

•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Attaching the Stand

You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper direction.

1 Spread a thick and soft cloth over a table as shown below.

Place the main unit face down onto it. Make sure not to damage the screen. At least two people are required at this step.

2 Align the 2 stand hooks with the two hooks under the bottom of the main unit (shown by arrow ➀), then slide the stand in the direction as shown by arrow ➁until it stops and the 3 mounting holes are aligned.

3 Drive Phillips pan screws in the 3 threaded holes at the bottom of the stand until they are tight.

➂screw holes

➁

front

side

➀

➀

To remove the stand from this unit

Unscrew the Phillips pan screws indicated by above “➂”screw holes. After the screws are removed pull the stand up toward the rear of the unit. Be careful not to drop the stand when you remove it.

Note:

•When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.

•Make sure to use a table which can support the weight of this unit and is larger than this unit.

•Make sure the table is in a stable location.

6

EN