24571.1 en.qxd
Test reception
This menu allows you to check the strength of the signal you are receiving through your aerial.
Setup
Installation
Service lists | • | Frequency |
Service setup | • | Network name |
Test reception | • | Signal quality |
|
| Signal strength |
Test signal quality
Close
&From the digital mode, press the DIGITAL MENU key to display the Setup menu.
éUse the cursor down to select Installation and press the cursor right to display the Installation menu.
“Use the cursor down to select Test reception and press the cursor right.
You obtain an indication of the actual programme frequency, the network name, the signal quality and strength.
‘You now have to enter the frequency of the digital channel you want to test.
Your TV magazine can provide the list of digital channel numbers. Use the table on page 38 to get the frequency.
(If the signal quality and strength is poor, a message appears at the bottom of the menu prompting you to enter the frequency between the lower and the higher limit.
If after keying the frequency, the reception is still poor, you can try improving, renewing, adjusting or updating the aerial. It is however advisable to contact a specialised aerial installer in order to achieve best results.
English
Language and location preferences
This menu allows you to select your preferred language for audio, subtitle, teletext and menu and make changes to the location (country and time zone).
Setup
Preferences
Languages | • | Audio |
Location | • | Subtitle / Teletext |
Digital Audio Output • | Subtitling mode | |
|
| Subtitling for hearing impaired |
System
Select your preferred language
Close
&From the digital mode, press the DIGITAL MENU key to display the Setup menu.
éUse the cursor down to select Preferences and press the cursor right.
“Use the cursor up/down to select Languages, Location or Digital Audio Output and press the cursor right.
‘Use the cursor up/down to select a setting and press the cursor right to enter into the sub- menu. Make your adjustment and press the OK key or the cursor left to exit.
Language default settings
•Audio : to select the audio sound language.
•Subtitle/Teletext : to select the subtitle/teletext language.
•Subtitling mode : off, on or auto (subtitle only displayed in case of original audio transmission).
•Subtitles for hearing impaired : to activate or deactivate the specific subtitle for hearing impaired (if made available by the broadcaster).
•System : to select the menu language.
Location settings
•Country : to select the country where you are located.
•Time zone : to select the time zone where you are located.
Digital Audio Output settings
•Select AC3 (if the signal is broadcasted and if the amplifier connected supports the Dolby Digital format).
•Select PCM if the amplifier connected doesn’t support Dolby Digital format. See also Connect Peripheral Equipment, MultiChannel Surround receiver, p. 32.
(Press the DIGITAL MENU key to exit the menu.
11
